The Team! Left to right: Kyle Doyle – The Labview expert and electronic wiz Jimmy Fung – The numerical and back-end programmer Phil Smith – The Mechatronic and logistic guy Daniel Sims – The master of machinists and team leader Expo Day Gallery Haptic Pen Close […]
Our old name, “Group 10 – Planar Cable-Suspended Haptic Interface for the Rehabilitation of Fine Motor Skills” is too long for our table’s sign. So we needed a shorter, hipper name for the Expo this week. We looked through a few names, and ultimately settled on the snazzy “Cable-Assisted Scripting […]
We spend the first half of the day on the manual Acer mill roughing the outer dimensions of the eyelet plates. One of the skills we learn in the department is how to read a vernier caliper. The technology is old, but vernier tend to produce more consistent measurements than digital […]
We had the CAD review today. We gained valuable insight into tolerancing drawings and working with drawings from vendors. Here is a picture of our table. We were required to place the finished parts on top of the drawings for the inspection by the faculty.
It seems someone has gotten labview to work with unity. This could make a good virtual environment wrapper for our project. [youtube]http://www.youtube.com/watch?v=Cf9blViDoG4[/youtube]
Welcome to Columbia Blogs. This is your first post. Edit or delete it, then start blogging!
